TDS & EC Calibration
- HM Digital meters come factory calibrated (at 342 PPM or 1413 µS, depending on the product) and are ready to use out of the box. They are designed to stay consistent. However, after prolonged usage, it may help to recalibrate your meter using a commercial standard NaCl-based solution (for most HM Digital meters), which is approximately, 0.5 µS of conductivity.
- Immerse the meter into the calibration solution. If the meter does not read within 2% of the calibration solution, adjust the reading by either digital calibration (for some products) or inserting a mini screwdriver (not included) into the trimmer pot (the hole on the back of the meter). Turn the trimmer clockwise to increase the reading and counterclockwise to decrease the reading. Note that the adjuster is very sensitive.
En español
1.-Medidores HM vienen de fabrica calibrados (a 342 PPM o 1413
µS, dependiendo del producto) y estan listos para usar al desepacar. Estan hechos para mantenerse "calibrados". Pero despues de prolongado tiempo de uso, necesitan ayuda para calibrarse usando una solucion estandar de NaCl (
Cloruro de sodio) (Para la majoria de los medidores HM), que esta aproximadamente a 0.5
µS de conductividad.
2- Introduzca el medidor en la solucion para calibrar. Si el medidor no mide 2% de la calibracion de la solucion, ajuste la lectura en el panel digital (para algunos productos) o insertando un destornillador (no incluido) en orificio detras del medidor. Mover el destornillador en el sentido del reloj para aumentrar el valor de lectura y en contra para disminuirla. Nota: es muy sensible.
Eso es lo que esta en la pagina oficial
http://www.tdsmeter.com/calibration_maintenance.html
Asi que lo que esta atras deberia de ser un tornillo, revisalo bien
Saludos.